26
Fig. 36
Fig. 34
Fig. 37
8
Attaching the Cord Hanger (CH3-CH)
(Figs. 34 & 35)
}When the CH3-CH cord hanger is attached on the back of the micro-
scope frame, the power cord can be wound around the cord hanger for
storage.
Engage the hook
2
of the cord hanger
1
into the air vent groove on the
back of the microscope frame by aligning the mount position, apply the
cord hanger to bring it in close contact with the microscope frame and
then slide the cord hanger down to fix.
# When carrying the microscope, do not hold it by the cord hanger.
Otherwise, the cord hanger would detach and cause the microscope
to drop, which may also cause injury.
Removal
To prevent electric shock, disconnect the power cord in advance and do
not use a thin Allen wrench but always use the provided Allen wrench.
Place the microscope frame at the edge of the desktop
4
, insert the
Allen wrench
5
into the bottom of the cord hanger
1
, push the Allen
wrench in directions and to move the cord hanger upward
and remove it.
9
Connecting the Power Cord
(Figs. 36 & 37)
The power cord is vulnerable when bent or twisted. Never subject it
to excessive force.
Make sure that the main switch is set to “ ” (OFF) before connect-
ing the power cord.
Always use the power cord provided by Olympus. If no power cord
is provided, please select the proper power cord by referring to the
section “PROPER SELECTION OF THE POWER SUPPLY CORD” at
the end of this instruction manual.
1. Connect the power cord’s connector
1
to connector
2
firmly.
Be sure to supply power from a grounded, 3-conductor power outlet
using the proper power cord. If the power outlet is not grounded
properly, Olympus can no longer warrant the electrical safety perfor-
mance of the equipment.
2. Connect the power cord’s plug
3
to a wall power outlet
4
.
Fig. 35
1
2
1
4
5
1
2
3
4
3