DMTA048-01EN, Rev. C, February 2013
44 Chapter 4
Leaving water in the pump when it is no longer in operation could result in damage
to the pump and its accessories. In order to avoid algae accumulation in the water or
to avoid the water from freezing (below
0 °C)
, we strongly recommend that you drain
the water pump each time you finish using it.
To drain the water pump
1.
Remove the water inlet tube from the water tank.
2.
For CFU03 and CFU05 pumps only: Fully open the flow control valve.
3.
Start the pump using the appropriate start/stop button (on the pump or the
remote control), depending on the power connection.
4.
Stop the pump when it is fully drained and no more water is flowing out of the
water outlet tube.
4.3
Cleaning the Water Pump
A few tips should be followed when cleaning your unit.
To clean the water pump
1.
Disconnect the power plug from the AC power outlet (wall).
2.
Insert the power cable’s LEMO connector in the pump’s
I
/
O
receptacle, to avoid
having water enter the pump’s power connection.
3.
Use a damp cloth and mild soap to clean the water pump.
4.4
Unfreezing the Water Pump
We recommend unfreezing the pump prior to operation:
•
When the pump was in storage below 0 °C.
•
When the pump was in transportation below 0 °C.
•
When the pump was in any place below 0 °C.
Downloaded from
Summary of Contents for CFU03
