DMTA048-01EN, Rev. C, February 2013
Connections 23
2. Connections
In this section, all of the connections are described both in diagrams and procedures.
Pay special attention to, and comply with the following instruction, in step 1 of many
connection and disconnection procedures: “Ensure that the pump is turned off.” Not
respecting this instruction could result in a bad power connection in the long term
due to sparks. Figure 2-1 on page 23 illustrates the difference between the Off position
and the On position. In the On position, the Start/Stop (
I
/
O
) button is pressed down.
Figure 2-1 Position of the Start/Stop button when the pump is turned off
Off position
:
The green inside surface of the
Start/Stop (
I
/
O
) button is at the same
height as the top of the outside ring.
On position
:
The green inside surface of the
Start/Stop (
I
/
O
) button is lower than the
outside ring. The button is pressed
down.
Downloaded from
Summary of Contents for CFU03
