Olympus CFU-PWZ, User Manual

Page: 44 / 72

DMTA048-01EN, Rev. C, February 2013
40 Chapter 3
3.2 Operating the CFU05
This section explains the operating procedure of the CFU05 water pump.
To operate the CFU05
1. Ensure that all connections on the pump are correctly made. See chapter 2
“Connections” on page 23.
2. Ensure that all connections on the scanner and wedges are correctly made.
3. Ensure that the filter end of the pump’s inlet tube is clean and in good working
condition. See section 4.1 “Maintaining the Water Inlet Tube’s Suction Filter” on
page 43.
4. Place the filter end of the pump’s inlet tube below the water level in the water
tank.
5. Place the end of the
SUCTION
’s water-outlet tube into the water tank.
6. Start the pump using the green start/stop button.
7. Adjust the water flow as required, using the outlet’s flow control valve.
8. Turn on the air supply and adjust the air pressure to obtain the desired water
suction on the wedge.
9. When you have finished your inspection and the unit is no longer required, turn
off the pump using the green start/stop button, disconnect the power supply, and
then remove the power plug from the AC power outlet.
10. Drain the water pump. See section 4.2 “Draining the Water Pump” on page 43.
3.3 Operating the CFU-PWZ
This section explains how the operating procedure of the CFU-PWZ water pump.
To operate the CFU-PWZ
1. Ensure that all connections on the pump are correctly made (see chapter 2 on
page 23).
2. Ensure that all connections on the PipeWIZARD are correctly made.
3. Ensure that the filter end of the pump’s inlet tube is clean and in good working
condition. For details, see section 4.1 “Maintaining the Water Inlet Tube’s Suction
Filter” on page 43.
Downloaded from ManualsNet.com search engine