DMTA048-01EN, Rev. C, February 2013
Operation 39
3. Operation
This section presents the usual procedures to setup, operate during inspection, and
shut down the CFU Water Pumps.
3.1
Operating the CFU03
This section explains the operating procedure of the CFU03 water pump.
To operate the CFU03
1.
Ensure that all connections on the pump are correctly made. See chapter 2
“Connections” on page 23.
2.
Ensure that all connections on the scanner and wedges are correctly made.
3.
Ensure that the filter end of the pump’s inlet tube is clean and in good working
condition. For details, see section 4.1 “Maintaining the Water Inlet Tube’s Suction
Filter” on page 43.
4.
Place the filter end of the pump’s inlet tube below the water level in the water
tank.
5.
Start the pump using the green start/stop button.
6.
Adjust the water flow as required, using the outlet’s flow control valve.
7.
When you have finished your inspection and the unit is no longer required, turn
off the pump using the green start/stop button, disconnect the power supply, and
then remove the power plug from the AC power outlet.
8.
Drain the water pump. See section 4.2 “Draining the Water Pump” on page 43.
Downloaded from
Summary of Contents for CFU-PWZ
