DMTA048-01EN, Rev. C, February 2013
26 Chapter 2
Figure 2-4 Metallic connection with female connector on pump
2.2
Power Connection
The voltage requirement for the CFU Water Pumps is 100 VAC to 240 VAC. You must
ensure that your power feed meets this requirement. The power cord supplied with
the power supply varies, depending on your location.
2.2.1
Connecting the Power Supply to the CFU Water Pumps
This section documents the standard power connection procedures. If you want to use
the CFU-PWZ
with the remote control, see section 2.2.2 on page 27.
To connect the power supply to the water pump
1.
Ensure that the pump is turned off.
2.
Align the pins of the power supply’s LEMO connector with the holes of the CFU
power connection’s
DC
IN
receptacle (Figure 2-5 on page 27).
3.
Insert the LEMO connector into the
DC
IN
receptacle.
4.
Insert the power cable in the power supply unit’s AC In connection and the power
plug in an AC power outlet (wall).
5.
Ensure that the pump is on its feet. Do not position the equipment so that it is
difficult to disconnect the power supply LEMO connector in case of emergency.
CFU-PWZ:
Water
OUTLET
to
PipeWIZARD
Downloaded from
Summary of Contents for CFU-PWZ
