Olympus BIX III, User Manual

Page: 57 / 102

10-015490-01EN, Rev. 2, June 2020
Local Area Network Communication 49
4. Local Area Network Communication
You must establish a local area network (LAN) connection between your PC, tablet, or
other device and the BTX III analyzer before you can use a web browser to run the
SwiftMin® software (see “SwiftMin® Software User Interface” on page 57).
You can set up the BTX III
to communicate with a LAN using one of the two
following methods:
• Connect an Ethernet cable to the Ethernet connector to establish a wired LAN.
• Connect a wireless LAN dongle to the USB connector to establish a wireless LAN.
Your PC, tablet, or other device must be wireless LAN (WLAN) enabled with a
compliant 802.11b/g/n connection.
The device you use to communicate with the BTX III must be capable of supporting
the full functionality of the SwiftMin® software.
Your LAN must be capable of connecting using Dynamic Host Configuration Protocol
(DHCP). If your network does not recognize DHCP, contact your IT department for
the proper addresses.