DMTA-10022-01EN, Rev. C, January 2015
Software Options
83
Figure 6-11 The range of the waveform display
6.4.3.1
Selecting the Range Value
There are fixed ranges available for each transducer frequency. The available ranges
are also dependent on material sound velocity. These selectable ranges let you adjust
the thickness span of the waveform display to show only the thickness range being
measured, and thus obtain maximum waveform resolution for each application. The
range setting affects only the waveform display. It is possible to make measurements
even when the display range does not show the detected echo from which the
thickness is measured. The range cannot be manually set while the zoom is active.
To select the range value
1.
In the measurement screen, press the
[
]
and
[
]
keys to adjust the range.
The waveform range changes to the next higher available range.
2.
Continue pressing the
[
]
key to select the next higher range, or press the
[
]
key
to select the next lower range.
The range value recycles to the minimum range value following the maximum
value.
Selectable range value
Adjustable delay value
Units
Summary of Contents for 45MG
