DMTA-10022-01EN, Rev. C, January 2015
Chapter 6
112
OR
Set
DELETE MODE
to
FILE
if you want to completely erase the file from the
memory.
f)
Press
ENTER
to confirm the operation.
Figure 6-31 Deleting a file
If you select multiple files for deletion, and some of those files are delete-protected,
the 45MG will only delete the files that are not delete-protected.
6.7.4.6
Deleting a Range of IDs
It is possible to delete a range of IDs in the active file by using the clear memory
function. This function deletes both the data and the ID number locations for
incremental and manual (built in GageView) data files. For other data file types, only
the data is deleted, not the ID number locations.
To delete a range of IDs in a file
1.
In the measurement screen, press
[FILE]
, and then select
DELETE
.
2.
In the
DELETE
screen (see Figure 6-32 on page 113), set
DELETE
ON
to
ID
RANGE
.
NOTE
Summary of Contents for 45MG
