DMTA-10004-01EN, Rev. D, November 2016
Using Special Functions
115
Figure 8
‑
2 The DIFF screen
When
DIFF MODE
is set to
REDUCTION RT
only:
d)
In
FORMER THICKNESS
, enter the original thickness value, as measured
before bending the metal.
e)
In
LARGE FONT
, select which measurement appears at the bottom of the
measurement screen with the large font (
THICKNESS
or
REDUCTION RT
).
4.
Press
[MEAS]
to return to the measurement screen with the displayed differential
value.
8.2
Using the Minimum, Maximum, or Min/Max Thickness Mode
You can activate the minimum, maximum, or min/max thickness mode to also display
retained minimum and/or maximum thickness values. The
MIN
and/or
MAX
values
appear on the left side of the main thickness reading (see Figure 8-3 on page 116). The
minimum or maximum thickness value replaces the main thickness display when the
transducer is uncoupled or when a loss-of-signal (LOS) occurs. The replacing value
appears with outlined digits.
Summary of Contents for 38DL PLUS
