Users Guide for NC-350A Currency Counter
5
If the various function settings of the machine were pre-set by the previous operator, the machine will
automatically default back to these previous selections when you turn the machine back ON.
If you wish to change the default function setting, please see the section headed ‘Function Setting’ -
(See Page 6).
It is vitally important to adjust the distance between the two Note Guides according to the length of the
notes you will be counting. Place the notes in the Hopper, ensuring that the lower notes within the
bundle are inserted firmly into the rear of the feed area.
The correct Feed Gap setting of the Central Feed Roller assemblies is vitally important to the smooth
functioning of the machine. After extremely long-term usage, the urethane components of both the
Feed Roller and the Friction Roller may be subject to natural wear. Under this condition, the Feed
Gap may become too wide and, as a result, Error Codes will be generated and note feeding will
become erratic.
To check and adjust the Feed Gap to counteract this simple wear condition, please use the following
procedure:
1.
Manually insert a genuine bank note into the Feed Gap and pull it rearwards, if you did not feel
any resistance whilst removing the note, this indicates the gap is too wide. If you feel the
resistance is very strong, it indicates the Feed Gap is too narrow. (When the machine leaves
our factory, the initial setting of the Thickness Dial is 8).
2. If the Feed Gap is found to be too wide, please adjust the Thickness Knob (which is mounted on
the right side cover) clockwise to slowly reduce the Feed Gap until the proper slipping- resistance
is achieved with your bank note.
3. If the Feed Gap is found to be too narrow, please adjust the Thickness Knob counter- clockwise
to increase the feed gap until the proper slipping-resistance is achieved with your bank note.
The machine will start counting automatically.
The machine will stop automatically under the following Conditions:
l
All the notes in the Hopper have been counted.
l
The machine count has achieved the pre-set batch quantity.
l
When an error occurs - An Error Code message will be shown on the display. Please refer to the
Troubleshooting ‘Error Code’ table at the end of this Users Guide.
