Olsen PERFORMANCE TABLE, User Manual

Page: 19 / 72

19
8 - Installation
The installation of the Performance Table must be done by Olsen certified technician, it consists in
assembling the armrests, the auxiliary pillow positioning, as well as checking the mains voltage which will
supply the equipment and, if necessary, make the tension adjustment. In case of optional items have been
purchased, these should also be installed at this time.
The technician will also verify if the equipment complies with the purchasing order, if it maintains its
integrity, and will provide operation, cleaning and maintenance guidance.
When the installation is complete, observe the following items:
−
All remote foot pedal or hand control commands are working perfectly.
−
The equipment memorizes the work positions and executes them correctly.
−
The upholsteries and auxiliary pillow are intact.
In the case of optional items have been purchased; check the items below according to the acquired
optional item:
−
Integrity of upholstery and finishes.
−
Joints without rigidity while moving.
−
The attachment of the accessory is secure.
−
If it has the water unit, it is correctly installed, has good water flow, adequate drainage of the spittoon bowl
and no leaks.
−
The accessories provided with the water unit are well fitted on the supports, have no leaks and have their
perfect drive.
−
The operating light turns On/Off normally and presents a smooth arm movement.
8.1 - Equipment Positioning
To position the equipment, put it on the stretcher position (backrest down and leg rest up) then take
it to the place where it will be used. Perform the movements of raising and lowering the seat, making sure
that there is enough room for all movements.
8.2 - Olsen Certified Technical Assistance Network
To access the Olsen certified technical assistance network for installation and maintenance contact
us by e-mail export3@olsen.odo.br or if you 55 48 2106 6000.
Installation should only be made by an authorized technician. Installation performed by an
unauthorized person will result in loss of warranty.
9 - Cleaning and Disinfection
The whole sanitize process must be done with the use of gloves suitable for cleaning and protection,
in addition to a mask and protective glasses, according to biosafety standards.
9.1 - Upholsteries and Plastic Covers
The plastic covers and upholsteries must be cleaned with a damp cloth containing neutral soap or
detergent only. Olsen advises against using any chemical product to clean these parts, but in the case of
disinfection products, it is important to check if it has suitable compatibility and specifications before use
on these materials.
To clean the operating light Premium’s multifaceted mirror, use only a soft cloth dampened with liquid
glycerin.
Never use hypochlorite or alcohol-based products.
9.2 - Painted Parts
It must be cleaned with a slightly damp cloth containing only soap or mild detergent.
Never use hypochlorite or alcohol-based products.