4-30
XZAC4219-03
4.5
OPERATIONS TO LOAD THE FIRMWARE
On all models of the PR2 Plus, to update the firmware release, the Toolbox (version 1.10_08 and higher) must
be installed.
Note: Before installing the Toolbox, it is essential to remove any previous installation
version from the Host.
For reasons of speed, it is advisable to update the firmware release using the USB port.
Proceed as indicated below:
•
Switch on the PR2 Plus holding down the
Station 2
key in order to print the
Self Test
and check that the
machine is set for USB data exchange (see
Interface
item). Otherwise, set the machine Set Up
parameter correctly (par.
4.2
).
•
Switch off the printer.
•
Switch the printer on again after checking that it is connected to the Host via the USB cable.
•
Start the
Toolbox
application and select the
Resource Kit
icon.
•
Select the
printer FW
icon