XZAC4219-03 Service
Manual
9-11
9.2.5
DISASSEMBLY/REASSEMBLY OF THE FLAT CABLES OF THE PRINTHEAD
•
Remove the casing as explained above.
•
Free the cable clip (1) on the right-hand side of the structure, unclipping it from the inside (2) of the
structure.
•
Remove the sound-proofing material (3).
•
Loosen the lock-screw (4) of the rear cable clip, rotate the cable clip and free the flat cable.
•
Rotate the flat cable support connected to the printhead (5) upwards to its stopping point.
•
Slide out the mylar (6) from the lower part of the flat cable support, then free the flat cable from the clips
of the support.
Figure 9-10
1
2
6
5
3
4