Field Service Ver. 1.0 Feb. 2007
6. Finisher
13
PK-512/513
Adjustment / Setting
6.1.2
Punch Horizontal Position
6.1.3
Punch edge detection
Functions
• Adjusts the horizontal position of the punch holes.
Use
• To change the horizontal position of the punch holes.
Adjustment
Specifica-
tion
• Make a copy in the punch mode and make an adjustment so that the width B is within
the following range.
• Specifications: B=10.5 mm
• Adjustment range: -5.0 mm to +5.0 mm (1 step=0.1 mm)
Adjustment
instructions
• To make width B greater : Enter the value of [+]
• To make width a smaller : Enter the value of [-]
Setting/
procedure
1.
Call the Service Mode to the screen.
2.
Touch [Finisher].
3.
Touch [FS-FN adjustment].
4.
Touch [Punch Horizontal Position].
5.
Touch [Main body].
6.
Set the correction value using the [+]/[-] keys.
7.
Touch [OK] twice to return.
8.
Touch [Exit] on the Service Mode screen.
9.
Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
10.
Make a copy and check the punch hole positions again.
B
A04EF3C501DA
Functions
• Adjusts the sensitivity (light intensity) of the paper size detect board of the punch kit.
Use
• This adjustment is made at the time of setup.
Adjustment
Specifica-
tion
1.
Call the Service Mode to the screen.
2.
Touch [Finisher].
3.
Touch [FS-FN adjustment].
4.
Touch [Punch edge detection].
5.
Touch Start key.
6.
Confirm that the result is OK.
NOTE
• When NG appears, check whether the punch kit is properly installed.
7.
Touch [OK] twice to return.
8.
Touch [Exit] on the Service Mode screen.
9.
Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
Y108421-6 Service Manual