Olivetti PG L2435, Operation Manual, Page: 52 / 222

Connecting and Printing 4-3
Connecting the Power Cord
Install the printer close to an AC wall outlet. If an extension cord is used,
the total length of the power cord plus extension should be 5 meters (16
feet) or less.
1
Connect the power cord to the Power Cord Connector at the rear of
the printer.
2
Connect the other end of the power cord to a power outlet.
3
Press the Power Switch to On ( | ). The printer begins to warm up.
Note Ensure the printer's power switch is off. Only use the power
cord supplied with the printer.
IMPORTANT If you install the starter toner container and switch
on the power, after a moment the message
Please
wait(Adding toner)
is displayed. When the printer is first
switched on after toner installation, there will be a delay of
approximately 15 minutes before the printer gets ready to print.
Once the
[Ready] indicator lights, printer installation is complete.