Olivetti PG L2435, Operation Manual, Page: 189 / 222

7-82 Using the Operation Panel
2
Press

or

to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified password. Use

and

to move
the cursor right and left. Enter a password consisting of between 0
and 16 digits.
3
Once you enter the correct ID and password, the Admin (change)
screen appears. (E.g.: Where the administrator ID is
00000001
)
Each time you press

or

, the following settings to be changed
appear in succession.
• Change ID
• Change Password
4
Press [OK] again. The administrator ID and password are confirmed.
5
Press [MENU] . The display returns to
Ready
.
Change ID (Administrator ID change)
You can use this to change the administrator ID.
1
In step 3 in Password (Administrator Password input) above, press

or

while the Admin (Change) screen is displayed until
>Change
ID
appears. (E.g.: Where the administrator ID is
001
)
2
When you press [OK] , a blinking cursor (
_
) appears.
3
Press

or

to increase or decrease, respectively, the value at the
blinking cursor. Enter the ID to be changed. Use

and

to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4
Press [OK] . A confirmation screen appears. (E.g.: Where the
administrator ID is changed to
002
)
5
Press [OK] . The new administrator ID is confirmed.
6
Press [MENU] . The display returns to
Ready
.
Note If you enter the incorrect administrator ID or password,
the
Wrong ID
or
Wrong Password
message appears and
the input screen then reappears. Re-enter the ID or password
correctly.
>Change ID
00000001
Note
If a change is required, refer to the procedures in
Change ID (Administrator ID change) and Change Password
(Administrator Password change) below.
>Change ID
001
>Change ID
_
OK?
002