Olivetti PG L22 Special, Service Manual, Page: 56 / 165

Y103920-3 Service Manual
56
Descroption LED
Table 5-1 (3/5)
Indicates that a print request was sent to the tttt tray that has
become empty. A message for setting mmmm paper.
TRAY1
TRAY2
MPF * Scroll display.
Print request has been made to the 2nd tray route cover open. To
continue, close cover. * Scroll display
The media type in the tray and the edit media type do not match.
TRAY1
TRAY2
MPF * Scroll display
The paper size in the tray and the edit size do not match.
TRAY1
TRAY2
MPF * Scroll display
RS232C Overflow has Occurred.
To continue, press ON-LINE switch(RS232C related)
RS232C Over Run has Occurred.
To continue, press ON-LINE switch(RS232C related)
RS232C Parity Error has Occurred.
To continue, press ON-LINE switch(RS232C related)
RS232C Framing Error has Occurred.
To continue, press ON-LINE switch(RS232C related)
Initializing (rebooting) a section related to NIC.
MSG blinks only on the top LCD line. (NIC-related)
Toner Low has passed, and almost no toner is left in the cartridge. For
temporary operation, open/close the cover or press “ON-LINE” switch, to
recover the printer operation. But basically you must change the toner
cartridge.
Displayed after printing 100 sheets after Toner Low was sensed, to
prompt the user to change the cartridge. after this, the printer
recovers with Cover Open/Close or when user presses “ON-LINE”
switch, then, after printing 30 pages, this message is displayed.
Even after this, the printer recovers when the user opens and
closes the cover, or he presses the “ON LINE” switch, but this
message is displayed for each sheet ejected.
During Change Drum Alarm, however, “CHG DRUM /(the lower line
spaces), not this message, is displayed, to prompt the operator to
replace the drum, and prevent him from replacing the toner.
Memory capacity has overflowed due to the following reasons. To
continue, press ON-LINE switch. Install expansion RAM or de-
crease the data amount.
- Too much print data in a page.
- Too much Macro data.
- Too much DLL data.
- After frame buffer compression, overflow has occurred.
* Scroll display
Warns that paper of the inappropriate size has been fed from the
tray. Check whether Multi-feed has happened.
To continue for Recovery Print, open and close the cover.
* Scroll display
Paper jam occurred when paper was being fed from tttttt tray.
TRAY1
TRAY2
MPF * Scroll display
Jam has occurred in the paper path.
Paper Feed
Transport (Message of 10.5 is displayed)
* Only Exit jam is identified.
* Scroll display
No Light
No Light
No Light
No Light
No Light
No Light
No Light
No Light
Varies
No Light
No Light
No Light
No Light
No Light
Status level
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
LCD
LOAD mmm
tttt EMPTY
CLOSE COVER
TRAY2 COVER OPEN
CHANGE PAPER TO
mmmm/pppp
tttt MEDIA MISMATCH
CHANGE PAPER TO
mmmm/pppp
tttt SIZE MISMATCH
RS232C
OVERFLOW
RS232C
OVER RUN
RS232C
PRY ERR
RS232C
FRM ERR
NETWORK
INITIAL
TONEREMP
CHG CART
MEMORY
OVERFLOW
OPEN UPPER COVER
PAPER SIZE ERROR
CHECK tttt
PAPER JAM
OPEN UPPER COVER
PAPER JAM