Olivetti PF-P09, Service Manual

Page: 188 / 457

Field Service Ver. 1.1 May 2011 13. SERVICE MODE
145
ADJUSTMENT
/ SETTING
13.4.13 TRANSFER POWER- DUPLEX PASS
A. Use
• Adjust the 2nd image transfer output (ATVC) on the duplexed pages for each media type.
• To use when the transfer failure at the trailing edge occurs.
B. Procedure
• The default setting is 0.
-8 to +7
1. Select [TRANSFER POWER] and press the Select key.
2. Select [DUPLEX PASS] and press the Select key.
3. Select desired media type with the up key
S
/down key
T
and press the Select key.
4. Select desired setting value with the up key
S
/down key
T
and press the Select key.
<Adjustment instructions>
To increase the ATVC value (in the direction of a foggier image), decrease the setting value.
To decrease the ATVC value (in the direction of a less foggy image), increase the setting
value.
13.4.14 IMAGE ADJ PARAM
A. Use
• Adjusts the printer in case of an image quality problem (uneven density)
• To correct image quality problems (uneven density) due to the machine being operated
at a high altitude.
B. Procedure
• The default setting is 0.
0 to 6
13.4.15 TEMPERATURE
A. Use
• When fusing performance is poor, or wax streak or offset occurs when the type of paper
is changed or environmental conditions change.
• Use this function when curled paper, or paper misfeed as a result of the curled paper,
occurs under varying environmental conditions or depending on the type of paper used.
B. Procedure
• PLAIN PAPER: -10
q
C to 0
q
C (step: 5
q
C)
• THICK: -10
q
C to 0
q
C (step: 5
q
C)
• ENVELOPE: -10
q
C to 0
q
C (step: 5
q
C)
1. Select [TEMPERATURE] and press the Select key.
2. Select the type of paper and press the Select key.
3. Select desired setting value with the up key
S
/down key
T
and press the Select key.
<Adjustment instructions>
If fusing performance is poor, increase the setting.
If wax streaks occur, decrease the setting.
If offset is poor, decrease the setting.
If curling of the paper occurs, decrease the setting.
d-Color MF2400