Olivetti d-COPIA 3500MF, Service Manual

Page: 218 / 753

2LL/2LJ/2LH
1-3-156
U464 Setting the ID correction operation
Description
Turns ID correction (calibration) on or off. Also, this allows individual settings for calibration oper-
ation.
Purpose
To restrict calibration when poor image quality is generated. Also, this allows individual settings
for calibration depending on the user preferences.
To perform the calibration when replacing the maintenance kit.
Method
1. Press the start key.
2. Select the item to be set.
Setting: [Permission]
1. Select On or Off.
Initial setting: On
2. Press the start key. The setting is set.
Item No. Description
Display Description
Permission Setting to turn calibration on/off
Time Interval Setting the interval time of calibration after printing
Mode Setting the calibration execution mode
On/Sleep Out Setting execution parameters for calibration when powered up
or reverted from auto-sleep
AP/NE Paper interval calibration ON/OFF setting at the time of cali-
bration/near end after toner feed
Leaving Time Setting the standard time for judging whether or not to carry
out calibration based on the sleep time when the machine
recovers from the sleep mode
Driving Time Setting the standard time for judging whether or not to carry
out paper interval calibration based on the driving time during
printing
Timing Setting the standard time for judging whether or not to carry
out calibration based on the continuous print driving time dur-
ing printing
Target Value Setting the sensor target values for toner thick layer calibration
and light amount calibration
Calib Executing the calibration
Display Description
On Turns calibration ON
Off Turns calibration OFF
Service Manual Y113350-5