Olivetti d-Copia 3002MF plus, Service Manual

Page: 208 / 752

1-3-141
Setting: G
1.Select the item to set.
2.By using [Left/Right cursor] keys or the numeric keys, enter the values which are shown on the back page
of the adjustment original.
3.Press the [Start] key to set the setting value.
Setting: B
1.Select the item to set.
2.By using [Left/Right cursor] keys or the numeric keys, enter the values which are shown on the back page
of the adjustment original.
3.Press the [Start] key to set the setting value.
Setting: Adjust Original
*: This setting is usually unnecessary.
1.Measure the distances "A", "B" and "C" from the upper edge of black belt 1 to the lower edge of black belt
3 of the adjustment original.
Measurement procedure
1) Measure the distance "A", "B" and "C" between two points as follows. (A: 30mm from the left edge, B:
105mm from the left edge, C: 180mm from the left edge)
?Measure the distance from the leading edge to the top edge of black belt 1.
2) Apply the following formula for the values obtained: ((A+B+C)/3)
2.Enter the value solved in "Lead" using the the [+] [-] keys keys.
3.Press the [Start] key to set the setting value.
4.Measure the distance "F" from the left edge to the right edge of black belt 2 on the adjustment original.
Measurement procedure
Measure the distance "F" from the left edge at 21mm from the top edge of black belt 1to the right edge of
black belt 2.
5.Enter the values measured in "Main Scan" using the the [+] [-] keys keys.
6.Press the [Start] key to set the setting value.
Items Contents Setting range Initial
setting
Data
variation
L L parameter setting 0.0 to 100 67.8 -
a A value setting -200 to 200 -51.3 -
b B value setting -200 to 200 48.9 -
Items Contents Setting range Initial
setting
Data
variation
L L parameter setting 0.0 to 100 38.8 -
a A value setting -200 to 200 25.3 -
b B value setting -200 to 200 -22.8 -
Items Contents Setting range Initial
setting
Data
variation
Lead Set the adjustment value of the
leading edge. 4.0 to 6.0 5.0 0.1mm
Main Scan Sets the adjustment value of the
left edge. 9.0 to 11.0 10.0 0.1mm
Sub Scan Set the adjustment value of the
trailing edge. 189.0 to 191.0 190.0 0.1mm
Y11 8 240-1
Service Manual