Olivetti d-Copia 1801MF Plus, Service Manual, Page: 139 / 492

2NC/2NF/2NG/2NN/3P7/3P8/3P9-2
1-3-85
U610 System Setting 1
Description
Makes settings for fax reception regarding the sizes of the fax paper and received images and
automatic printing of the protocol list.
Method
1. Press the start key.
2. Select the item to be set.
Display Description
Cut Line:A4 Sets the number of lines to be ignored when receiving a fax (A4R/Let-
terR) in the auto reduction mode.
Cut Line:100% Sets the number of lines to be ignored when receiving a fax at 100%
magnification.
Cut Line:Auto Sets the number of lines to be ignored when receiving a fax in the auto
reduction mode.
Setting the number of lines to be ignored when receiving a fax (A4R/LetterR) in the auto
reduction mode
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when the data is recorded in the auto reduction mode onto A4R or LetterR paper
under the conditions below.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the
entire data on a page is further reduced so that it can be recorded on the same page.
1. Change the setting using the right/left arrow keys or numeric keys.
Description Setting
range Initial
setting Change in
value per step
Number of lines to be ignored when receiving a
fax (A4R, letter) in the auto reduction mode 0 to 22 0 16 lines
* : Increase the setting if a page received in the reduction mode is over-reduced and too much
trailing edge margin is left. Decrease it if the received image does not include all transmit-
ted data.
2. Press the start key. The value is set.
Setting the number of lines to be ignored when receiving a fax at 100% magnification
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when recording the data at 100% magnification. If the number of excess lines is below
the setting, those lines are ignored. If over the setting, they are recorded on the next page.
1. Change the setting using the right/left arrow keys or numeric keys.
Description Setting
range Initial
setting Change in
value per step
Number of lines to be ignored when receiving at
100% 0 to 22 3 16 lines
* : Increase the setting if a blank second page is output, and decrease it if the received image
does not include the entire transmitted data.
2. Press the start key. The value is set.