Olivetti d-Copia 1801MF Plus, Service Manual

Page: 42 / 492

2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-2-12
Before loading paper
When you open a new package of paper, fan
the sheets to separate them slightly prior to
loading in the following steps.
1. Bend the whole set of sheets to swell them
in the middle.
2. Hold the stack at both ends and stretch it
while keeping the entire stack swelled.
3. Raise the right and left hands alternately to
create a gap and feed air between the
papers.
4. Finally, align the papers on a level, flat
table.
*: If the paper is curled or folded, straighten
it before loading. Paper that is curled or
folded may cause a jam.
Figure 1-2-15
*: Load the paper with the print side facing
up.
*: After removing new paper from its pack-
aging, fan the paper before loading it in
the cassette.
*: Before loading the paper, be sure that it is
not curled or folded. Paper that is curled
or folded may cause paper jams.
*: Ensure that the loaded paper does not
exceed the level indicator (see illustration
below).
*: The paper length and width guides must
be adjusted to the paper size before load-
ing the paper. Loading the paper without
adjusting these guides may cause
skewed feeding and paper jams.
*: Be sure that the paper length and width
guides rest securely against the paper. If
there is a gap, readjust the guides to fit
the paper.
Figure 1-2-16