Olivetti d-COLOR P2026, Service Manual, Page: 123 / 207

(3) Detaching and refitting the main PWB
Procedure
1. Remove the hard disk* or network inter-
face card, if installed.
*: 26/28 ppm model only
2. Remove the IF cover (see page 1-5-3).
3. Remove two pins and then remove the
hard disk or network interface card.
Hard disk
Pin
Pin
Figure 1-5-41
4. Remove the top cover (see page 1-5-3).
5. Remove the right rear cover, right cover
and right lower cover (see page 1-5-5).
6. Remove three screws and then remove
the power source shield.
Screws A and B are unidentical, there-
fore, do not mix up.
Screw A
Screw B
Power source shield
Screw A
Figure 1-5-42
1-5-29