Olivetti d-color MF651, Service Manual, Page: 691 / 1053

Field Service Ver. 2.0 Jul. 2009 14. BILLING SETTING
631
ADJUSTMENT
/ SETTING
14.3.5 Management Function Choice-Authentication Device 2
A. Use
• To set whether or not the authentication device 2 is installed.
• Set when the authentication unit (biometric type or card type) is mounted.
Card 1 : Uses IC card authentication system (AU-201)
Card 2 : Uses loadable device card authentication system
Bio1 : Uses biometrics (finger vein) authentication system (AU-101)
Bio2 : Uses biometrics (finger vein) authentication system (AU-102)
• When selecting [Bio1], set a film timeout interval.
• When selecting [Bio2], set a film timeout interval, capture trial time and authentication
trial time.
• When selecting [Card 1] or [Card 2], a response timeout interval is displayed.
(The interval is unchangeable.)
• When the setting is set to Card 2, the main power switch must be turned OFF and ON to
let the new setting take effect.
• Selecting Card 2, a loadable device driver allows to install.
B. Procedure
<Authentication Mode>
Card 1 Card 2 Bio1 Bio2
(1) Installing method of the loadable device driver
• The firmware is updated using the USB memory device.
NOTE
• NEVER remove or insert the USB memory device with the machine power turned
ON.
1. Prepare a USB memory device on which the driver data of the loadable device to be
used was written.
2. Turn OFF the main power switch.
3. Remove the screw [1].
4. Loosen the screw [2], and lift up the cover [3] of the USB port.
5. Insert the USB memory device to the USB port [4] for service.
[1]
[2] [3] [4]
A0P0F2C570DA
Y110571-1 Service Manual