Olivetti d-color MF651, Service Manual, Page: 662 / 1053

12. SERVICE MODE Field Service Ver. 2.0 Jul. 2009
602
ADJUSTMENT
/ SETTING
12.16.6 FS-FN adjustment - Punch vertical position (Z-fold)
A. Use
• To adjust the position of the punch hole in the sub-scanning direction when ZU is in use.
• Make the adjustment upon setup of ZU-606.
B. Procedure
1. Make a copy sample in the punch mode.
2. Make an adjustment so that the width A is within the following range.
Standard value
• It is possible to adjust the A dimension of half of the top and bottom by ± 0.5 mm from the
standard value.
• It is not possible to adjust the A value of the distance between holes.
Setting range: -5.0 to +5.0 mm (1step = 0.1 mm)
3. Call the Service Mode to the screen.
4. Touch [Finisher]
o
[FS-FN adjustment]
o
[Punch vertical position (Z-fold)].
5. Select [ALL] and make the setting using [+] or [-].
To make width A greater: Enter the Value of [+]
To make width A smaller: Enter the Value of [-]
NOTE
• The adjustment setting value used for each paper size is the value set with [ALL]
plus the value set for each paper size.
6. Touch [OK] twice.
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
9. Make copies in the punch mode again and check that the punch hole positions have
been adjusted properly.
A
A A
A
A
A
A109F3C501DA
A Top and bottom center gap
2-4 hole 80 ± 0.5
Top and bottom A dimension 1/2 ± 1 2-3 hole (2 hole) 70 ± 0.5
2-3 hole (3 hole) 108 ± 0.5
Service Manual Y110571-1