Olivetti d-color MF651, Service Manual, Page: 660 / 1053

12. SERVICE MODE Field Service Ver. 2.0 Jul. 2009
600
ADJUSTMENT
/ SETTING
12.16.4 FS-FN adjustment - Punch Horizontal Position
A. Use
• To change the horizontal position of the punch holes.
B. Procedure
1. Make a copy sample in the punch mode.
2. Make an adjustment so that the width B is within the following range.
<For PK-516>
Specification B: 9.5 mm (2-3 hole), 11.0 mm (2-4 hole), 10.5 mm (SWE4 hole)
Adjustment range: -5.0 mm to +5.0 mm (1 step: 0.1 mm)
<For PK-517>
Specification B: 9.5 mm ± 1.0 mm (2-3 hole), 11.0 mm ± 1.0 mm (2-4 hole),
10.5 mm ± 1.0 mm (SWE4 hole)
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
3. Call the Service Mode to the screen.
4. Touch [Finisher] o [FS-FN adjustment] o [Punch Horizontal Position].
5. <For PK-516>
Touch the paper size where punch horizontal position is adjusted.
<For PK-517>
Touch the paper type where punch horizontal position is adjusted.
6. Look at the copy and adjust the punch horizontal position with the [+]/[-] key.
To make width B greater : Enter the value of [+]
To make width a smaller : Enter the value of [-]
7. Press the Reset key.
8. Touch [Exit] on the Service Mode screen.
9. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
10. Make another set of copy sample and check the amount of deviation (A).
A11TF3C511DA
B B B
A11TF3C503DA
Service Manual Y110571-1