Olivetti d-color MF651, Service Manual, Page: 400 / 1053

10. UTILITY Field Service Ver. 2.0 Jul. 2009
340
ADJUSTMENT
/ SETTING
(2) Original Stop Position
<Use>
• To manually adjust the original stop position and the read position in each of the ADF
modes.
• When the result is Unable in the [Auto Adj. of Stop Position].
<Procedure>
1. Place the chart in the document feed tray (with the side having an arrow facing up).
2. Make a full size copy of the chart.
NOTE
• In the same way place the chart with the blank side facing up in the document feed
tray in the duplex mode and make a copy. Check the difference in the widths of a
between the chart and the second sided surface of the copy sample.
3. Check that the difference in the widths of B between the chart and the copy sample falls
within the specified range.
Specification B: 0 ± 2.0 mm
Adjustment range: -4.0 mm to +4.0 mm (1 step: 0.1 mm)
4. Call the Administrator Settings to the screen.
5. Touch [System Settings]
o
[Expert Adjustment]
o
[ADF Adjustment]
o
[Original Stop
Position].
6. Look at the copy and adjust [Front] or [Back] with the [+]/[-] key.
If the difference in the widths of B is greater than the specifications, enter the [+] value.
If the difference in the widths of B is smaller than the specifications, enter the [-] value.
7. Touch [OK].
8. Make a copy of the chart again and check that the difference in the widths of B falls
within the specified range.
B
A0P0F3C601DA
Service Manual Y110571-1