Olivetti d-color MF651, Service Manual, Page: 382 / 1053

10. UTILITY Field Service Ver. 2.0 Jul. 2009
322
ADJUSTMENT
/ SETTING
(5) Punch Horizontal Position Adjustment
<Use>
• To change the horizontal position of the punch holes.
<Procedure>
1. Make a copy sample in the punch mode.
2. Make an adjustment so that the width B is within the following range.
<For PK-516>
Specification B: 9.5 mm (2-3 hole), 11.0 mm (2-4 hole), 10.5 mm (SWE4 hole)
Adjustment range: -5.0 mm to +5.0 mm (1 step: 0.1 mm)
<For PK-517>
Specification B: 9.5 mm ± 1.0 mm (2-3 hole), 11.0 mm ± 1.0 mm (2-4 hole),
10.5 mm ± 1.0 mm (SWE4 hole)
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
3. Call the Administrator Settings to the screen.
4. Touch [System Settings]
o
[Expert Adjustment]
o
[Finisher Adjustment]
o
[Punch
Horizontal Position Adjustment].
5. <For PK-516>
Touch the paper size where punch horizontal position is adjusted.
<For PK-517>
Touch the paper type where punch horizontal position is adjusted.
6. Look at the copy and adjust the punch horizontal position with the [+]/ [-] key.
To make width B greater: Enter the value of [+]
To make width a smaller: Enter the value of [-]
7.
8. Touch [OK].
9. Make another set of copy sample and check the amount of deviation (B).
A11TF3C511DA
B B B
A11TF3C503DA
Service Manual Y110571-1