Olivetti d-color MF651, Service Manual, Page: 381 / 1053

Field Service Ver. 2.0 Jul. 2009 10. UTILITY
321
ADJUSTMENT
/ SETTING
(4) Punch Vertical Position Adjustment
<Use>
• Adjusts the vertical position of the punch holes.
<Procedure>
1. Make a copy sample in the punch mode.
2. Make an adjustment so that 1/2 of the length A is within the following standard range.
Specifications:
2-4 hole: A=80 ± 0.5 mm (It is not possible to adjust the A value of the distance between
holes.), 1/2 of the vertical length A ± 1.0 mm
2-3 hole (2 hole): A=70 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
2-3 hole (3 hole): A=108 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
SWE4 hole: B1=70 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
SWE4 hole: B2=21 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
Adjustment range: -5.0 mm to +5.0 mm (1 step: 0.1 mm)
3. Call the Administrator Settings to the screen.
4. Touch [System Settings] o [Expert Adjustment] o [Finisher Adjustment] o [Punch
Vertical Position Adjustment].
5. Touch the paper size where punch vertical position is adjusted.
6. Look at the copy and adjust the punch vertical position with the [+]/[-] key.
To move the hole position upward: Enter the value of [+]
To move the hole position downward: Enter the value of [-]
7. Touch [OK].
8. Make another set of copy sample and check the amount of deviation (A).
A
A11TF3C510DA
A
A
A
A
A
A2
A2
A1
A11TF3C501DA
Y110571-1 Service Manual