Oliver 6303, Owner'S Manual

Page: 34 / 50

34 |
Page Oliver Machinery 6303 Sander
Inspect / Adjust Belt Tracking
Run the sander for 5-10 seconds to observe the
tracking of the sanding belt. The sanding belt
should track in between the upper and the lower
edges of the drums as it oscillates.
If adjustment is needed:
1. Turn off the sander.
2. Loosen the lock nut
3. Rotate the belt tracking adjustment bolt
CLOCKWISE to raise the belt on the drum,
and COUNTERCLOCKWISE to lower the belt
on the drum.
4. Adjust belt tracking by rotating the bolt 1/4
turn at a time. Tighten the lock nut and turn
on the machine to verify the adjustment.
5. Repeat steps 1-4 as needed.