Oliver 4275C, Owner'S Manual

Page: 27 / 70

4275C Jointer OLIVERMACHINERY.NET 27 | Page
Infeed Table Depth Stop Knob
As a safety feature, a depth stop is set up to
prevent the depth of cut goes beyond 1/8” for
jointing operations. To get more than 1/8” depth
of cut for rabbeting operations, pull and hold the
knob when lowering the infeed table.
Outfeed Table Height Adjustment
The outfeed table height adjustment lever is
located below the outfeed table. The outfeed
table height is locked by a locking cap screw.
Fence
This precision ground cast iron fence has two
adjustable positive stops at 90° and 135°.
The fence can be retracted and raised above the
table to provide additional clearance for
servicing the cutterhead.