Oliver 4265C, Owner'S Manua, Page: 48 / 71

48 |
Page Oliver Machinery 4265C Jointer
Align Belt Pulleys
The belt pulleys were aligned in the factory and
should not require further adjustments. Check
pulley alignment if the belt is slipping off the
pulleys, or if the belt wears prematurely.
1. Disconnect the jointer from the power
source!!
2. Remove the motor access panel and the belt
cover.
3. Use a straight edge or a tight string to check
the alignment of the belt pulleys.
4. Adjustments can be made by shifting the
motor pulley. Loosen the two set screws
with a 5mm hex wrench, and the motor
pulley can move along the motor shaft.
5. Realign the motor pulley with the
cutterhead pulley.
6. Retighten the motor pulley locking screws,
then close the belt cover and motor access
panel when adjustments complete.