Oliver 4235, Owner'S Manual, Page: 40 / 64

40 | Page Oliver Machinery 4235 Jointer
9. When the outfeed table is adjusted, tighten
the set screws to lock all outfeed table
eccentric nuts.
10. With the outfeed table height set and locked,
gently rock the fence to ensure the outfeed
table is stable. If the outfeed table is rocking,
eliminate all gaps between the table,
eccentric nuts, and bracket.
11. Adjust the infeed table using the infeed table
eccentric nuts so it is coplanar with the
outfeed table.
Repeat the steps in “ Inspect
Infeed Table ” when making adjustments.
Again, make sure the eccentric nut is fully
inserted into the bracket.
12. Lock all eccentric nuts when adjustments
complete.
13. With the infeed table realigned, it may need
additional adjustments.
See section “ Infeed
Table Adjustments ” for details.
14. Reinstall all panels and cutterhead guard
when all adjustments complete.
Infeed Table Adjustments
After a full table realignment, the infeed table
height should be re-zeroed, and a few
components of the infeed table will need to be
adjusted.
1. Disconnect the jointer from the power
source!!
2. To re-zero infeed table height, raise the
infeed table so it is approximately at the
same height as the cutting arc of the
cutterhead.
3. Place a straight edge over the infeed table so
it hangs over the cutterhead.
4. Fine-tune the table height to set the depth
of cut to zero. When properly set, cutters
should be barely scraping the straight edge
when the cutterhead rotates.
5. Check if the depth scale is still pointing at
zero. If not, loosen the screw on the pointer
and adjust its position. Also, check and
adjust the quick stop plates to make sure
they stop the lever at 0” and 1/2".