Oliver 10014, Owner'S Manual

Page: 16 / 65

16 |
Page Oliver Machinery 10014 Planer
Electricals
WARNING
All electrical work must be done by a qualified electrician, and must meet the
electrical code in your area.
Minimum Circuit Size Required for Model 10014 Planer
Stock Number Minimum Circuit Size Required
10014.201
20A
Please ensure the electrical circuit for this machine meets the minimum circuit size requirement.
Minimum circuit size requirement applies to a dedicated circuit which provides power to one 10014
Planer. If more machines are sharing the same circuit, consult a qualified electrician to ensure the
designated circuit is properly sized for safe operation.
If a circuit is available, but not meeting the minimum circuit size requirement listed above, a new circuit
must be installed for this machine.
Grounding
WARNING
Improper grounding can cause electric shock, fire, and equipment damage.
Proper grounding reduces the risk to the operator in the event of electrical malfunction or breakdown.
This machine must be connected to the grounding conductor when available, and all grounding
connections must meet or exceed the electrical code requirements in your area. Furthermore, all
grounds must be verified and must meet or exceed the electrical requirement of the machine. If
grounding is not available. Consider the use of a GFCI protection device as an alternative, if this complies
with the electric code in your area.
Electrical Wiring
This machine is not pre-wired with a plug. A 7-feet long 14 AWG cord is
provided for connecting this machine to a power source. If you plan to
connect the machine directly to the electrical panel (“Hardwiring”).
Please ensure there is a readily accessible electrical disconnect near
the machine. Refer to section “Wiring Diagram” for wiring your
machine to a power source.
If you choose to connect this machine with a plug and a cord, please
use a UL/CSA listed plug. If you need an extension cord to connect to the power outlet, select a durable
cord type with high temperature rating (90C° or above). Both plug and power cord must be sized to
meet the amperage requirement of your machine.