POWERED BY
FLUIDIGM
LAN
AC 100–240V
50–60Hz, 8A
US
BU
SB
HDMI
COMPRESSION AIR INLET
(OPTIONAL)
70–90 PSI ONLY
Main power switch
IMPORTANT:
Wait at least 15 sec after turning off the instrument before turning it back on.
5.7 Turn On and Start-Up the System
When the system is turned off, turn it on by toggling on ( | ) the main power switch on the instrument’s rear panel.
The system starts up, and the instrument initializes all system components and software. It also performs a set of
instrument checks to ensure that the system components are working correctly. The system can remain turned on when
not in use.
NOTE:
If not planned to be used, e.g., for a week, turn off Olink
®
Signature Q100 to save power.
5.8 Abort a Run in Progress
IMPORTANT:
Aborted runs cannot be restarted. Discard any chips from aborted runs.
If you need to abort a run in progress:
1. Tap
(Abort) at the bottom of the screen, then tap
OK
to end the run in progress.
50