Olimpia splendid Unico Air R410A, Instructions For Use And Maintanence

Page: 78 / 489

30
EN - 30
ENGLISH
The air conditioner has to defrost its battery periodically.
During this operation the air conditioner does not heat the room,
though its internal parts remain on except for the room air fan.
when the outdoor temperature is very low, there may be a slight
delay for passage from the minimum to the medium or maximum
speed from when the command is sent to the machine with the
remote control.
Like delays might occur on activating the swinging function of the
mobile baffle.
After having turned off the unit, the internal fan runs seconds more.
Then it stops and both air flaps close.
3.5.9 - Checking airflow direction
• Press key B8 on the remote control to activate/deactivate the continuous oscillation
of the moving air outlet deflector (1).
• When continuous oscillation is active, an additional press of the key B8 allows to
lock the deflector so as to obtain the desired vertical direction for the air flow.
The moving deflector position must never be forced manually.
3.5.10 - Checking fan speed
• The fan speed check occurs through key B5 (on the remote control).
• Pressing several times this key will cause speed to change according to the fol-
lowing sequence:
Low > Medium > High > Automatic.
• The higher the speed setting, the greater the output of the air conditioner but also
the louder its operation.
• By setting the Automatic mode, the onboard microprocessor adjusts the automatic
speed. The higher the difference between the room temperature detected and the
temperature set, the higher the speed.
• The start of the compressor is
indicated by the lighting up of
the LED B (green) located on
the console (fig.30).