Olimpia splendid Bi2 WALL TR 1000, Instructions For Use And Maintenance Manual, Page: 78 / 449

~8m
20
EN - 30
ENGLISH
7.4.3 - Location of the remote controller
• Keep the remote control in a position from
which the signal can reach the appliance
receiver (maximum distance is about 8
meters - with charged batteries) (fig. 20).
The presence of obstacles (furniture,
curtains, walls, etc.) between the remote
control and the appliance reduces the
remote control range.
7.5 - APPLIANCE SWITCHING ON/OFF
In the event that a main switch has been installed on the power line, it must be
switched on.
a . To switch on/off the appliance, press the “ ” (T2) key for 2 seconds.
b. The appliance can be switched on or off by pressing key “ B1 ” on the remote
controller.
All the timers are reset when the appliance is switched off.
The absence of any light signal identifies the ‘stand-by’ status, absence of function.
When the control is set to this mode of operation, it ensures safety against freezing.
In the event that ambient temperature drops below 5°C, the hot water solenoid valve
and the fan motor at minimum speed are activated, the display shows code “AF”.
7.6 - AUTOMATIC COOLING /HEATING MODE
Setting this type of adjustment allows the control to automatically carry out the selection
of cooling or heating mode, based on the difference between temperature set by the
user and ambient temperature.
a. To activate/deactivate this function, keep the cooling/heating selection key “ T3 ”
pressed for 10 seconds until the blue and red symbols (A5) light up alternatively.
This setting is maintained also in the event of power interruption.
b. Then, ensure that when the set temperature is changed, the unit alternates cooling
only (blue indicator “A5” on), fan (blue and red indicators off) or heating only (red
v “A5” on) mode.
In this mode, read ambient temperature compensation is disabled.
This setting can only be carried out from the panel on board the machine.
If automatic mode is active, it is not possible to change the oper -
ating mode from the remote controller.