Olimpia splendid Astomi 200, Instructions For Installation, Use And Maintenance Manual

Page: 30 / 76

ENGLISH
EN-
PROBLEM POSSIBLE SOLUTION
The appliance does not work. Power plug: Disconnect it from the power outlet and plug it in again.
Power Failure: When the power is returned, try again.
Air blows but water vapor is
not produced.
There may be oil residues in the reservoir; wash the reservoir and
try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk
(Fig. L).
If you use hard water, replace with softer water.
Humidity level is low. The surface of the ultrasonic disk is dirty: Clean ultrasonic disk
(Fig. L).
The water in the unit is too cold: Replace with cool, but not cold
water.
The humidity has a bad smell. Poor maintenance or dirty water: Accurately clean the reservoir and
fill it up with clean water.
White powder is formed near
the appliance.
Hard water may deposit a certain of dust. Dust in the air also settles
because of added humidity in the room. Use distilled water if this
becomes a nuisance.
The appliance has stopped
working.
Little or no water. Unplug the appliance and fill up the reservoir.
Water accumulates outside
the appliance or around it.
Humidity saturation. Lower the mist control setting.
Point the nozzle away from objects. Lift the appliance onto a wa-
ter-resistant levelled surface at least 60 cm above the floor.
The appliance will not start. Too much water in the reservoir. Do not exceed the MAX marking.
8 - TROUBLESHOOTING GUIDE
14