Olimpia splendid Astomi 200, Instructions For Installation, Use And Maintenance Manual

Page: 27 / 76

ENGLISH
EN-
c . Add the essential oil (Fig. E).
- for the “ ASTOMI 80 ” model > 2÷3 drops in 70 ml of water.
- for the “
ASTOMI 200
” model > 5÷10 drops in 200 ml of water.
Do not use more than this amount.
d . Place the cover (3) over the body of the appliance (1) (Fig. D).
- - - - - - - - - - - - - - - - - -
ASTOMI 80 model
(Fig. G)
e1 . Connect the USB plug of the power supply cable (8) to a socket that supplies voltage
of at least 5V, 1A (or higher).
If the power supply is lower than 5V, 1A, only a small amount of mist is produced.
Normally, the USB power supply from a laptop is excellent, while USB power supply
from a desktop computer is not correct.
e2 . Connect the USB mini connector to the power supply socket (6) on the body of the
appliance; the LED light in the reservoir switches on for one second.
- - - - - - - - - - - - - - - - - -
ASTOMI 200 model (Fig. H)
f1 . Connect the feeder (7) to the power input and the plug (7a) to the power outlet (6)
on the body of the appliance. The appliance emits a “beep” and the LED light in the
reservoir switches on for one second.
• Make sure the power mains voltage corresponds to
the information on the feeder (8).
• Only use the feeder (8) included with the product.
SWITCH-ON (for all models)
g
. Press the button to start the appliance.
The appliance distributes the mist and the LED light in the reservoir switches on
alternating from red to green.
NOTE:
- If there is no water in the reservoir (2), when the button has
been pressed, the red LED flashes 3 times and switches off.
h . Press the button again to switch the LED light off (distribution continues).
i . Press the button to switch the appliance off.
6a - CLEANING AFTER USE
After each use, and if you wish to use another oil, proceed as follows:
Switch off the appliance and unplug it from the power
outlet.
a . Remove the cover (3).
b . Empty the reservoir (2) carefully so it does not come into contact with the air outlet
(Fig. F).
c . Rinse the reservoir and dry it carefully with a soft cloth or a paper towel to remove all
residues. Carefully clean and dry the ultrasound transducer (1a), if necessary, using
a soft brush (Fig. L).
11
ASTOMI