OLIMEX STM32-H107, User Manual

Page: 2 / 17

INTRODUCTION
STM32-H107 header board provides easy way for developing and prototyping with
the new STM32F107 connectivity line microcontroller, produced by
STMicroelectronics. STM32-H107 has JTAG port for programming and debugging,
USB_OTG, user button, two status leds, and most of the GPIOs are on extension
headers where you can connect your additional circuits.
BOARD FEATURES
- CPU: STM32F107 32 bit ARM-based microcontroller with 256 KB Flash, 64KB
RAM, USB OTG, Ethernet, 10 timers, 2 CANs, 2 ADCs, 14 communication
interfaces
-
JTAG connector with ARM 2x10 pin layout for programming/debugging
-
25 Mhz crystal
-
USB_OTG
-
Power Jack
-
WKUP button
-
RESET button
-
Two status leds
-
Power-on led
-
3V battery connector
-
Extension port connectors for many of microcontrollers pins
-
PCB: FR-4, 1.5 mm (0,062"), soldermask, silkscreen component print
-
Dimensions: 70x50mm (2.76x1.97")
ELECTROSTATIC WARNING
The STM32-H107 board is shipped in protective anti-static packaging. The board
must not be subject to high electrostatic potentials. General practice for working
with static sensitive devices should be applied when working with this board.
BOARD USE REQUIREMENTS
Cables: The cable you will need depends on the programmer/debugger you use. If
you use ARM-JTAG , you will need LPT cable, if you use ARM-USB-OCD , you will
need RS232 cable and 1.8 meter USB A-B cable and if you use ARM-JTAG-EW , you
will need 1.8 meter USB A-B cable.
Hardware: Programmer/Debugger – one of the Olimex ARM Programmers: ARM-
JTAG, ARM-USB-OCD, ARM-JTAG-EW.
Software:
ARM C compiler and JTAG programmer.
Note: For OpenOCD we don't offer any projects.
PROCESSOR FEATURES
Page2