30
a
b
Figure 36. T Sensor attached on the bottom of the Petri dish (a -b).
When possible close the Petri dish with its own plastic lid (or with Okolab SENSOR LID, to be ordered
separately) and place it in the appropriate sample holder.
Tip
►
It is recommended using an Okolab SENSOR LID (available for purchase) to secure the T Sensor in
place in the dish during calibration or operation in Sample Control mode.
SENSOR LID
T Sensor
Figure 37. SENSOR LID-35 for 35 mm Petri dish.
Sensor lids are available for the following: 35 mm, 60 mm Petri-dish, chamber slide and chambered cover
glass. Sensor Lids are ordered separately using the codes in following table.
SENSOR LID CODES
SENSOR LID-35
Temperature sensor lid. To be used in specimen feedback in a 35 mm Petri Dish
SENSOR LID-60
Temperature sensor lid. To be used in specimen feedback in a 60 mm Petri Dish
SENSOR LID-GS
Temperature sensor lid. To be used in specimen feedback in chamber slides and chambered
cover glass
Table 3. Sensors lid codes.
The Sample Control mode provides the
Open Incubator
feature. During the normal operation it could be
necessary to open the incubating chamber where the sample is placed. Follow the procedure as described below:
1.
Press on
Open Incubator
icon (see Figure 38 a).
2.
Open your incubator by removing the Chamber Lid.
3.
Close the incubating chamber and wait for 2 minutes in order to let the environment achieve steady state.
4.
Press on
Incubator Closed
icon and UNO-CONTROLLER recovers normal operation (see Figure 38
a).
