H301-ALPHA3-SMALL
User Manual
REV 02
www.oko-lab.com
Pa
ge
6
5.
Installing the H301-ALPHA3-SMALL around the sample
holder
To install the H301-ALPHA3-SMALL on the stage, please follow the steps below:
3.
Insert the chamber base by sliding into place as shown in image 1 and 2 in Figure 5.
Note:
Please pay attention to the sample holder glass.
4.
Tighten the captive screw M2 to fix the chamber base around the sample holder by using the provided hexagonal
key (see image 2 in Figure 5).
5.
Place the magnetic lid on the chamber base (see image 3 in Figure 5).
6.
Insert the sample arm cover (see image 4 in Figure 5), and close it (see image 5 in Figure 5). It allows to reduce
the brightness into the sample.
7.
Place the magnetic objective heater in place as shown in image 6 in Figure 5.
