Okofen PE 08, Operating Manual

Page: 83 / 170

Periphery Learning
83
Note:
This function is only possible if you use a bur-
ner control unit without heating controller to
regulate domestic hot water and heating
circuits.
USA Mode:
• Off: USA Mode not used
• On: USA Mode active
A finger pressure on the appropriate button
confirms the set value and takes you back to the
input field Periphery Learning.
This function must be enabled if a heating circuit
and a domestic hot water circuit are operated
without a heating controller.
The room temperature is regulated using a bus,
touch screen or analogue remote control.
The DHW temperature is regulated with a sensor
at boiler controller plug-in position R2.
A finger pressure on the appropriate button confirms the selected data and takes you back to the main
menu.
Note:
After a new periphery learning if the system has been operating, e.g.:
–after
Software updates
or
–
changings in the system
(installation of an additional boiler,...) ,
the
parametersettings
on the boiler controller (FRT-regulation, ignition-parameters, suction-interval,
etc.) will be set to factory set and have to be adjusted again.
Operating Manual PELLEMATIC® PE(S)(K)(B) 10 — 56