Technical Reference Guide – Operator interface > 75
2.
Press and hold down the SEL and LF/FF buttons together
and then set the Power Switch to ON.
A
DJUSTING
TOF
POSITION
Use the following procedure to set TOF to accord with the
reference position (23.28 mm (11/12 in)). The reference position
refers to the first line of the paper i.e. the position to which the
printer feeds the paper when automatically loading the paper.
1.
Print out the menu settings of the printer and confirm that
the TOF (in cut sheet mode or continuous forms mode) is
23.28 mm (11/12 in).
2.
Set the Paper Type lever to the required paper type.
3.
When continuous forms are used, place the paper on the
Pin Tractor.
For cut sheet mode, do not insert the paper at this stage.
4.
In continuous forms mode, press the LOAD/EJECT button.
5.
In cut sheet mode, place the paper in the Paper Tray and
press LOAD/EJECT.
6.
In off-line mode, press the following buttons to adjust the
first printing line:
To feed the paper forward by a small amount, press and
hold down the LOAD/EJECT button and then press the SEL
button.
To feed the paper backward by a small amount, press and
hold down the LOAD/EJECT button and then press the LF/
FF button.
NOTE
Adjusting of TOF can be done in cut sheet mode or continuous
forms mode.
NOTE
If the specified correction range is more than +-3.53 mm (20/
144 in) for ML1190 eco and +- 4.23 mm (30/180 in) for
ML1190 eco, the paper cannot be moved.
Summary of Contents for ML1120
