Oki LD670, User Manual

Page: 201 / 1345

199
13-2. Cutter Specifications
Cutting mode: Full cutting
Note : For printing on label paper, use only partial cutting. If full cutting is used
in such cases, paper cutting performance will deteriorate faster because of
the greater adverse effect of adhesive matter.
Note : Paper cutting performance may deteriorate faster with the use of label
paper because of its adhesive matter. Clean the cutter blade periodically to
remove the adhesive matter.
Note : Full cutting may lead to irregularities at the center of the cutting surface.
If paper fiber remains at these locations, this may eventually lead to
incomplete cutting at these locations.
Note : In full cutting mode, the printed paper must be removed each time that one
sheet is printed. Otherwise, printed paper remains in the automatic cutter
section and may cause a cutting error.
Note : The maximum number of successive cuts by the cutter is 30 cuts per minute
(at least two seconds per cut). Using the cutter at a higher rate may cause
afailure.