41
4
N E S T O R I G I N S E T T I N G
[
O K ?
Press the
key to fix the origin setting.
The carriage returns, and the Printer enters online state
(idle mode) and becomes ready to print.
N E S T O R I G I N S E T T I N G
P L E A S E W A I T
P R I N T R E A D Y
N E S T : 1 6 2 5 / P A P E R
To cancel the origin above, press and hold the key
for 1.5 seconds in the idle mode or raise the pressure
control knob. When the origin is cancelled, the display
returns from
[NEST]
to
[ROLL]
.
<Display when the origin is cancelled>
P R I N T R E A D Y
R O L L : 1 6 2 5 / P A P E R
Use the media until the very end
Even when the media end is detected during printing (online mode), a margin remains at the media bottom end.
This remaining margin can also be used for printing.
Print quality may be affected when printing near the media bottom end. Use this function only if you can afford this loss
in print quality.The tension bar on the supply side must be removed to print near the media bottom end. The media
advance adjustment value may not be adequate anymore after the tension bar has been removed, which may affect the
print quality.
Set roll end detection to
Action Selection
beforehand.
Detect Only
Printing stops when media end is detected.
Action Selection
Printing stops temporarily when media end error is detected.
Select
or
Cancel
with the operation panel.
1
á
I N K
M E D I A R E G
â
ß
M E D I A M . A D V
à
Set the Printer to offline state and press the
key.
2
# S E L E C T M E D I A
> 0 1 : T Y P E 0 1
[
・・・
With the
key scroll to [#SELECT MEDIA].
3
# R O L L E N D D E T E C T I O N
> 0 1 : D E T E C T O N L Y
[
Press the
key.
4
# R O L L E N D D E T E C T I O N
[
0 1 : D E T E C T O N L Y
[
Press the
key.
