42
Setting items
INK MENU
Menu
Outline of functions
#SET INK SUPPLY(ml)
#CCC:XXXX >
Set the quantity of ink supplied in the reservoir.
#REMAINING INK
>XX. XL
Display the amount of ink that can be used with the Printer.
#EXTEND INK AMOUNT
>
Extend the amount of ink that can be used with the Printer using an ink extension chip.
#READ EXTENSION CHIP
>
Check the information inside the ink extension chip.
#SUPPLY SUBCART INK
>
Supply ink in the subcartridges from the reservoirs.
MEDIA MENU
Menu
Outline of functions
ROLL(XXXXXX)
YYYmm
XXXXXX: Media name
YYYY: Media width
SHEET(XXXXXX)
YYYYmm
XXXXXX: Media name
YYYY: Media width
FACE(XXXXXX)
YYYYmm
XXXXXX: Media name
YYYY: Media width
BACK(XXXXXX)
YYYYmm
XXXXXX: Media name
YYYY: Media width
NEST(XXXXXX)
YYYmm
XXXXXX: Media name
YYYY: Media width
MEDIA REG MENU
Menu
Outline of functions
#SELECT MEDIA
>XX:YYYYYY
Select the media number of media to be registered or parameter-corrected.
#RENAME MEDIA
>XX:YYYYYY
Name (register) the media number selected in [SELECT MEDIA]. Six (6) digits of character (or code) can be
entered for the media name. For character string of 6 digits, codes, alphanumerics and katakana characters can
be used.
#SMART PASS
>XX:LOW
Select the intensity for the auto correction function which ameliorates the print quality (unevenness, etc).
#DENSITY
>XX:NORMAL
Select a print density.
#PRINT DIRECTION
>XX:BIDIR
Select a print direction.
#USE EDGE GUARD
>XX:YES
Select whether to use the media edge guard or not.
#SKEW CHECK
>XX:ON
Select whether to perform a skew check when printing.
#MEDIA ADV MODE
>XX:FWD ONLY
Select a media advance mode.
#MEDIA BACK MODE
>XX:BACK & FWD
Select a media advance mode.
#SUCTION FAN LEVEL
>XX:HIGH
Select the force (air volume of fan) to suck the media to the platen.
#AFTERHEATER T
>XX:30°C
Set the afterheater temperature. However, when “**” is set, the postheater does not work.
#PRINTHEATER T
>XX:40ºC
Set the printheater temperature. However, when “**” is set, the print heater does not work.
#PREHEATER T
>XX:40°C
Set the preheater temperature. However, when “**” is set, the preheater does not work.
#COLOR STRIPE
>XX:ON
Select whether to print color stripes or not.
#PH HEIGHT VAL
>XX:+0.0
Adjust the print head height.
#PH CLEANING
>XX:START & END
To keep the print head condition, select a cleaning mode which is automatically performed by the printer.