Oki IP-5630, User Manual, Page: 40 / 265

40
Loading the media
Loading the media on the printer
Procedure to load roll media
1
Open the front cover and slide the media
edge guards to each end of the platen. Then,
close the front cover.
Notes
‹
Move the media edge guards to both ends so they
cannot enter under the media.
‹
After completing the media replacement work, set the
media guards. After completing the media replacement
work, set the media guards (see Step 12 on
page
44
).
‹
When using media with adhesive applied to the core at
the end of the roll, this adhesive may stick to the paper
guide or the platen. In this case, always clean up the
adhesive before using the media.
2
Put the left side media holder in position and
fix it temporarily by turning the screw.
3
Move the right side media holder to the right
end.
Note
‹
When using media with adhesive applied to the core at
the end of the roll, this adhesive may stick to the paper
guide or the platen. In this case, always clean up the
adhesive.