Oki IP-5630, User Manual, Page: 241 / 265

241
Troubleshooting
Contours of objects are blurred.
[Symptom A] Basic image [Symptom B] [Symptom C] [Symptom D]
[Cause]
The ink dries too slowly.
The ink is ejected
excessively.
[Cause]
The print head position
is misaligned.
The bidirectional print
positions are misaligned.
[Cause]
The media advance
adjustment value is
not proper.
[Cause]
The static electricity
accumulated on the
media
Cause Solution
[Symptom A]
The ink dries too slowly.
The ink is ejected excessively.
(1) Decrease the temperature of all three heaters by 5°C. * 1
* Before starting the print, ensure that the heater temperatures have been decreased to
the target temperature.
(2) Change to a more suitable print mode, or set the carriage speed to SLOW.
* 1 * 2 * 3
(3) Print in unidirectional mode. * 2
(4) If printing in high density, print in normal density.
(5) Use proven media.
(6) With the RIP software, apply the profile with a low ink amount to be ejected.
* Note that the hue may change if the ejected ink amount decreases.
[Symptom B]
The print heads positions are misaligned.
The bidirectional print positions are
misaligned.
(1) Adjust the print heads positions. (
page 75
)
(2) Perform bidirectional adjustment. (
page 80
)
(3) If bidirectional adjustment has been performed automatically, perform it again
manually.
[Symptom C]
The media advance adjustment value is
incorrect.
Correct the media advance adjustment value. If media advance adjustment has been
performed automatically, perform it again manually.
- The adjustment value differs depending on the winding mode, tension or loose.
- Be sure to adjust the media advance adjustment value again after changing the suction
fan power.
- Be sure to adjust the media advance adjustment value again after changing the pressure
roller lever position.
- If the ionizer (option) is set to ON, set it to OFF.
- If automatic adjustment has been performed, perform manual adjustment.
[Symptom C]
The media advance accuracy is poor, or
is not stable.
(1) Check that the media was installed properly in the conditions below.
- The installed media is installed parallel to the printer.
- The operation panel shows the media type correctly.
- The media winding mode is optimal for the installed media.
- If the media is curled or wrinkled, see the description on the problem, The media is
curled or wrinkled.
(2) Adjust the pressure on the media with the pressure roller lever. * 1
(3) Change to a more suitable print mode, or set the carriage speed to SLOW.
* 1 * 2 * 3
(4) Check that the media is correctly stretched between the paper roll and the pressure roller.
* If the media is loose when performing the media advance adjustment, the value will be
incorrect.
(5) If the ionizer (option) is set to ON, set it to OFF.
Be
fo
re
p
rin
tin
g
Lo
adi
ng
the
m
edi
a
A
dj
us
tm
ent
M
ai
nt
enan
ce
A
dv
an
ce
d
op
er
ati
on
s
Trou
ble
sh
oo
tin
g
M
enu
tr
ee
Ap
pe
nd
ix